Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
4.1. Removal and installation of the power unit
4.2. Dismantling and assembly of the engine
4.3. Block of cylinders
4.4. Conrod and piston group
4.5. Bent shaft and flywheel
4.6. Gas distribution mechanism
4.7. Head of the block of cylinders of GA14DE and GA16DE engines
4.8. Head of the block of cylinders of the SR20DE engine
4.9. Cooling system
4.10. Lubrication system
4.11. System of production of the fulfilled gases
4.12. Power supply system
4.13. Complex Control System of the Engine (CCSE)
4.13.1. Subsystem of management of fuel injection
4.13.2. Subsystem of management of an ignition advancing corner
4.13.3. Preliminary checks
4.13.4. Check of electric parameters of a control system of the engine
4.13.5. Self-diagnostics of KSUD
4.13.6. Check and adjustment of idling and contents WITH in the fulfilled gases
4.13.7. Check and installation of an initial corner of an advancing of ignition
4.13.8. Check of technical condition of the sensor of a detonation (on the SR20DE engine)
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Schemes of electric equipment
 





7f435ca2


4-13-8-proverka-tekhnicheskogo-sostoyaniya-datchika-detonacii-na-dvigatele-sr20de.html

4.13.8. Check of technical condition of the sensor of a detonation (on the SR20DE engine)

Make sure that ignition is switched off. Disconnect a block of wires from the sensor and remove the sensor from the block of cylinders. Check whether is not present on the interfaced surfaces of the block of cylinders and the sensor of traces of corrosion and pollution. Screw the sensor in the block of cylinders.
"previous page
4.13.7. Check and installation of an initial corner of an advancing of ignition		 following page"
5. Diesel engines