Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
4.1. Removal and installation of the power unit
4.2. Dismantling and assembly of the engine
4.3. Block of cylinders
4.4. Conrod and piston group
4.5. Bent shaft and flywheel
4.6. Gas distribution mechanism
4.7. Head of the block of cylinders of GA14DE and GA16DE engines
4.8. Head of the block of cylinders of the SR20DE engine
4.9. Cooling system
4.10. Lubrication system
4.11. System of production of the fulfilled gases
4.12. Power supply system
4.13. Complex Control System of the Engine (CCSE)
4.13.1. Subsystem of management of fuel injection
4.13.2. Subsystem of management of an ignition advancing corner
4.13.3. Preliminary checks
4.13.4. Check of electric parameters of a control system of the engine
4.13.5. Self-diagnostics of KSUD
4.13.6. Check and adjustment of idling and contents WITH in the fulfilled gases
4.13.7. Check and installation of an initial corner of an advancing of ignition
4.13.8. Check of technical condition of the sensor of a detonation (on the SR20DE engine)
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Schemes of electric equipment
 





7f435ca2


4-13-7-proverka-i-ustanovka-nachalnogo-ugla-operezheniya-zazhiganiya.html

4.13.7. Check and installation of an initial corner of an advancing of ignition


Fig. 2.96. Tags for installation of the initial ignition advancing corner (IAC)


Warm up the engine up to the working temperature. Connect a stroboscope according to the instruction. Rasstykuyte socket of the sensor of provision of a butterfly valve. Launch the engine and leave it to idle. Check an ignition advancing corner, directing a lamp beam to the tags put on a pulley of a bent shaft (fig. 2.96). If necessary weaken fastening of the distributor of ignition and, turning the distributor, establish an ignition advancing corner according to the recommended value. Delay fastening of the distributor of ignition. Again check a corner of an advancing of ignition and disconnect a stroboscope. Join the socket of the sensor of provision of a butterfly valve.

"previous page
4.13.6. Check and adjustment of idling and contents WITH in the fulfilled gases
following page"
4.13.8. Check of technical condition of the sensor of a detonation (on the SR20DE engine)