Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
8.1. General information
8.2. Steering repair
8.2.1. Removal and installation of a shaft of steering
8.2.2. Removal and installation of the steering mechanism
8.2.3. Check of a free wheeling of a steering wheel
8.2.4. Check of axial movement of the mechanism
8.2.5. Check of effort of turn of a steering wheel
8.2.6. Check of effort of movement of a gear lath
8.2.7. Adjustment of an emphasis of a lath
8.2.8. Removal and installation of the pump of the hydraulic booster
8.2.9. Dismantling and assembly of the pump of the hydraulic booster
8.2.10. Removal of air from system of the hydraulic booster
8.2.11. Adjustment of a tension of a belt of the drive of the hydraulic booster
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Schemes of electric equipment
 





7f435ca2


8-2-8-snyatie-i-ustanovka-nasosa-gidrousilitelya.html

8.2.8. Removal and installation of the pump of the hydraulic booster


Fig. 6.9. Details of system of the hydraulic booster:
And — without ABS; B — with ABS; In — cars with the petrol engine; — cars with the diesel engine; Д — without oil cooling system; Е — with the oil cooling system; 1 — a tank;
2 — the pump of the hydraulic booster; 3 — a hose; 4 — the pipeline; 5 — the oil heater


Fig. 6.10. Details of the pump of the hydraulic booster of steering: And — cars with the petrol engine; B — cars with the diesel engine; 1 — a pulley; 2 — a lock ring; 3 — a power shaft; 4 — a cuff; 5 — a pump housing; 6 — a sealing ring; 7 — a distributive disk; 8 — blades; 9 — a rotor; 10 — pins; 11 — the stator; 12 — a pump cover; 13 — a fastening arm; 14 — the adjusting valve; 15 — the tension regulator


Details of system of the hydraulic booster of steering are shown in fig. 6.9 and 6.10. Press the pipelines suitable to the hydraulic booster or pump out liquid from a tank of the hydraulic booster. Remove the arm supporting a plait of wires. On cars with the petrol engine remove an arm of the top fastening from the right rack of a suspension bracket. Disconnect pipelines from a pump housing of the hydraulic booster, having muffled openings traffic jams. Take aside hoses, wires, sockets. Turn out the lower bolt of fastening of the pump of the hydraulic booster and a bolt of a natyazhitel of a driving belt; take off a belt. Turn out the remained bolts of fastening of the pump of the hydraulic booster and remove the pump.
Installation is carried out to the sequences, the return to removal.
Replace new sealing washers on pipelines.
Tighten fastening details the required moment.
Remove air and fill system of the hydraulic booster of steering (see below).
Check laying, and also connection of electric wires and pipelines.

"previous page
8.2.7. Adjustment of an emphasis of a lath
following page"
8.2.9. Dismantling and assembly of the pump of the hydraulic booster