Removal and installation of the steering mechanism. Nissan Almera (from 1995 to 1999 release)
Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
8.1. General information
8.2. Steering repair
8.2.1. Removal and installation of a shaft of steering
8.2.2. Removal and installation of the steering mechanism
8.2.3. Check of a free wheeling of a steering wheel
8.2.4. Check of axial movement of the mechanism
8.2.5. Check of effort of turn of a steering wheel
8.2.6. Check of effort of movement of a gear lath
8.2.7. Adjustment of an emphasis of a lath
8.2.8. Removal and installation of the pump of the hydraulic booster
8.2.9. Dismantling and assembly of the pump of the hydraulic booster
8.2.10. Removal of air from system of the hydraulic booster
8.2.11. Adjustment of a tension of a belt of the drive of the hydraulic booster
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Schemes of electric equipment
 









8-2-2-snyatie-i-ustanovka-rulevogo-mekhanizma.html

8.2.2. Removal and installation of the steering mechanism

In case of malfunction the steering mechanism is replaced assembled. Disconnect a wire from the negative plug of the rechargeable battery. Establish forward wheels in provision of the rectilinear movement. By means of the syringe pump out working liquid from a tank of the hydraulic booster.

Fig. 6.3. Bolts of fastening of brackets of a case of the steering mechanism to a body cross-piece


Remove the protection cover of a steering column for access and to the cardan hinge. Mark the provision of a steering shaft. Turn out a bolt of fastening of the cardan hinge. Remove an antisplash guard of the left wheel. Disconnect steering drafts from rotary fists for what to a rasshplintuyta and turn off nuts and a vypressuyta a stripper fingers of hinges from openings in rotary fists. Remove a reception pipe of the muffler. Separate connecting draft from the transmission. Press pipelines of the hydraulic booster and disconnect the union from a case of the steering mechanism, having muffled openings traffic jams. Turn out bolts of fastening of the steering mechanism to a cross-piece of a body (fig. 6.3) and take out the steering mechanism through an arch of the left wheel.

Fig. 6.4. Preliminary adjustment of length of steering draft: X = 187 mm


Fig. 6.5. Movement of a lath: And = 65 mm


Fig. 6.6. Order of an inhaling of bolts of support of fastening of a case of the steering mechanism


You carry out installation to the sequences, the return to removal. Attaching steering thirsts for rotary fists, establish distance of X, equal 187 mm (fig. 6.4). Check the size of movement of a lath of the steering mechanism which has to make 65 mm to the right and to the left (fig. 6.5), otherwise replace the steering mechanism. Establish a shaft of steering and a gear wheel of the steering mechanism on the tags put at removal. Tighten bolts of support of fastening of the steering mechanism in the order shown in fig. 6.6. Replace sealing rings of unions of pipelines. Remove air from system of the hydraulic booster of the steering mechanism. Check and if necessary adjust the angles of installation of wheels.


"previous page
8.2.1. Removal and installation of a shaft of steering
following page"
8.2.3. Check of a free wheeling of a steering wheel







7f435ca2