Removal and installation of the oil heater of the SR20DE engine. Nissan Almera (from 1995 to 1999 release)
Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
4.1. Removal and installation of the power unit
4.2. Dismantling and assembly of the engine
4.3. Block of cylinders
4.4. Conrod and piston group
4.5. Bent shaft and flywheel
4.6. Gas distribution mechanism
4.7. Head of the block of cylinders of GA14DE and GA16DE engines
4.8. Head of the block of cylinders of the SR20DE engine
4.9. Cooling system
4.10. Lubrication system
4.10.1. Removal, check and installation of the oil pump
4.10.2. Check of pressure of oil
4.10.3. Removal and installation of the oil heater of the SR20DE engine
4.10.4. Removal and installation of the oil pallet of the SR20DE engine
4.11. System of production of the fulfilled gases
4.12. Power supply system
4.13. Complex Control System of the Engine (CCSE)
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Schemes of electric equipment
 









4-10-3-snyatie-i-ustanovka-maslyanogo-radiatora-dvigatelya-sr20de.html

4.10.3. Removal and installation of the oil heater of the SR20DE engine


Fig. 2.76. Details of the oil heater of the SR20DE engine: 1 — an oil filter; 2 — the case of an oil filter; 3, 5 — a sealing ring; 4 — the oil heater; 6 — the central bolt


The oil heater is installed on the case of an oil filter and fastens a bolt in a back part of the block of cylinders (fig. 2.76).
Lift a forward part of the car and put it on supports.
Merge liquid from the cooling system. Disconnect hoses from the case of the oil heater. Mark the provision of a radiator before to remove it. Turn out the central bolt. You will substitute capacity for collecting the following oil. Remove sealing rings. Clear a radiator and blow it compressed air. If the radiator is damaged or corked, replace it new.
At assembly replace sealing rings. Establish a radiator on the tags made earlier. Tighten the central bolt. Execute the remained operations as it should be, the return to removal. Launch the engine and be convinced of lack of a leak. If necessary add oil and cooling liquid.

"previous page
4.10.2. Check of pressure of oil
following page"
4.10.4. Removal and installation of the oil pallet of the SR20DE engine







7f435ca2