Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
4.1. Removal and installation of the power unit
4.2. Dismantling and assembly of the engine
4.3. Block of cylinders
4.4. Conrod and piston group
4.5. Bent shaft and flywheel
4.5.1. Check of technical condition
4.5.2. Check of gaps between inserts and necks of a bent shaft
4.5.3. Check of an axial gap of a bent shaft
4.6. Gas distribution mechanism
4.7. Head of the block of cylinders of GA14DE and GA16DE engines
4.8. Head of the block of cylinders of the SR20DE engine
4.9. Cooling system
4.10. Lubrication system
4.11. System of production of the fulfilled gases
4.12. Power supply system
4.13. Complex Control System of the Engine (CCSE)
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Schemes of electric equipment
 





7f435ca2


4-5-1-proverka-tekhnicheskogo-sostoyaniya.html

4.5.1. Check of technical condition

Conrod and radical necks should not have zadir, scratches, overheat traces. The geometrical sizes of necks should not go beyond the specified limits. Otherwise it is necessary to execute regrinding of necks to the repair sizes. Inserts are not exposed to any repair operations and in case of wear are replaced with new. On inserts teases, peelings, scratches, etc. are not allowed.
"previous page
4.5. Bent shaft and flywheel		 following page"
4.5.2. Check of gaps between inserts and necks of a bent shaft