Dismantling and assembly of a rack of a forward suspension bracket. Nissan Almera (from 1995 to 1999 release)
Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.1.1. Removal and installation of a rack of a forward suspension bracket
7.1.2. Dismantling and assembly of a rack of a forward suspension bracket
7.1.3. Removal and installation of the stabilizer of cross stability
7.1.4. Removal and installation of a cross-piece of a forward suspension bracket
7.1.5. Check and adjustment of angles of installation of forward wheels
7.1.6. Replacement of the hug bearing of a forward wheel
7.2. Back suspension bracket
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Schemes of electric equipment
 









7-1-2-razborka-i-sborka-stojjki-perednejj-podveski.html

7.1.2. Dismantling and assembly of a rack of a forward suspension bracket


Fig. 5.7. Otvorachivany nuts of a rod of the shock-absorber


Establish the removed rack in a vice. By means of the device for compression of springs squeeze a spring before release of the top and lower support of a rack. Turn off a nut of a rod of the shock-absorber (fig. 5.7).
Remove the details which are over a spring. If you do not assume to collect a rack in the nearest future, carefully unclench a spring. Always replace shock-absorbers and springs in pairs, i.e. on the right and left wheels.
For assembly squeeze a spring if it was released after dismantling. Establish into place the removed details in the sequence, the return to removal. "Acquire", but do not tighten a nut on a shock-absorber rod. Finally tighten a nut after installation of the car on wheels. Slowly release a spring, watching that it reached the correct position concerning support. Install on the car a rack of a forward suspension bracket assembled.

"previous page
7.1.1. Removal and installation of a rack of a forward suspension bracket
following page"
7.1.3. Removal and installation of the stabilizer of cross stability