Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. General information
9.2. Brake mechanisms of forward wheels
9.3. Brake mechanisms of back wheels of drum type
9.4. Brake mechanisms of back wheels of disk type
9.5. Drive of brakes
9.6. Anti-blocking system of brakes
9.6.1. Principle of action
9.6.2. Removal and installation of the ABS hydrounit
9.6.3. Check and replacement of sensors of speed
9.6.4. Replacement of a rotor of the sensor of a forward wheel
9.6.5. Replacement of a rotor of the sensor of a back wheel
9.6.6. ABS diagnostics
10. Electric equipment
11. Body
12. Appendices
13. Schemes of electric equipment
 





7f435ca2


9-6-3-proverka-i-zamena-datchikov-skorosti.html

9.6.3. Check and replacement of sensors of speed


Fig. 7.18. Bolt of fastening of the sensor of speed of rotation of a forward wheel: 1 — the place for check of a gap of the sensor


Turn out a bolt of fastening of the sensor of a forward wheel (fig. 7.18) and take out the sensor from a landing nest. Otsoyedinitete the electric socket also measure the sensor resistance which has to make 0,8 — 1,2 kOhm. In case of discrepancy of the measured resistance to the specified value replace the sensor.

Fig. 7.19. Fastening of a wire of the sensor of speed of rotation of a back wheel. The arrow showed the sensor of speed of rotation of a wheel


 It is easy to execute replacement of the sensor of speed of rotation of a back wheel, being guided by fig. 7.19. Disconnect fastenings of its wire. Sensor resistance same, as at the sensor of a forward wheel.
At installation of sensors check gap size between the sensor and a rotor.


"previous page
9.6.2. Removal and installation of the ABS hydrounit
following page"
9.6.4. Replacement of a rotor of the sensor of a forward wheel