Removal of air from a hydraulic actuator of brakes. Nissan Almera (from 1995 to 1999 release)
Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. General information
9.2. Brake mechanisms of forward wheels
9.3. Brake mechanisms of back wheels of drum type
9.4. Brake mechanisms of back wheels of disk type
9.5. Drive of brakes
9.5.1. Removal and installation of the main brake cylinder
9.5.2. Removal and installation of the vacuum amplifier
9.5.3. Removal of air from a hydraulic actuator of brakes
9.5.4. Adjustment of the parking brake system
9.6. Anti-blocking system of brakes
10. Electric equipment
11. Body
12. Appendices
13. Schemes of electric equipment
 









9-5-3-udalenie-vozdukha-iz-gidroprivoda-tormozov.html

9.5.3. Removal of air from a hydraulic actuator of brakes

On the cars completed with the ABS system when performing this operation it is necessary to turn off previously electronic control by system.
Removal of air it is necessary to make every time after the operations connected with a detachment of pipelines, replacement of brake cylinders or at hit of air in system because of its leakage. The brake system of the car consists of two independent contours therefore removal of air is carried out from it in the following order: 1st contour: back right wheel, forward left wheel; then 2nd contour: back left wheel, forward right wheel.
For performance of this operation it is recommended to use the special installation deleting air from system under pressure.

"previous page
9.5.2. Removal and installation of the vacuum amplifier
following page"
9.5.4. Adjustment of the parking brake system