Removal and installation of the main brake cylinder. Nissan Almera (from 1995 to 1999 release)
Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. General information
9.2. Brake mechanisms of forward wheels
9.3. Brake mechanisms of back wheels of drum type
9.4. Brake mechanisms of back wheels of disk type
9.5. Drive of brakes
9.5.1. Removal and installation of the main brake cylinder
9.5.2. Removal and installation of the vacuum amplifier
9.5.3. Removal of air from a hydraulic actuator of brakes
9.5.4. Adjustment of the parking brake system
9.6. Anti-blocking system of brakes
10. Electric equipment
11. Body
12. Appendices
13. Schemes of electric equipment
 









9-5-1-snyatie-i-ustanovka-glavnogo-tormoznogo-cilindra.html

9.5.1. Removal and installation of the main brake cylinder


Fig. 7.13. Details of the drive of brakes: And — without ABS; B — with ABS; and — to the vacuum pump; 1 — a tank cover; 2 — a tank; 3 — sealing rings of a tank; 4 — the main brake cylinder; 5 — pressure regulators; 6, 7 — pistons of brake contours; 8 — sealing laying of the main brake cylinder; 9 — the stoplight switch; 10 — the spring forelock; 11 — a brake pedal; 12 — laying; 13 — a brake pedal axis; 14 — the vacuum amplifier; 15 — a vacuum hose


During the work be guided by fig. 7.13. Open a cowl. By means of the syringe pump out brake fluid from a tank. On the car with the petrol engine remove an air duct. Remove a tank and sealing rings. Disconnect unions of brake tubes from the cylinder, having marked them. Take measures for prevention of the passage of brake fluid. Muffle openings to avoid hit of dirt in them. Turn off from the vacuum amplifier of a nut of fastening of the main brake cylinder and remove it.
You make installation in the sequence, the return to removal. At the same time tighten threaded connections the ordered moment. After installation of the main cylinder remove air from a hydraulic actuator of brakes.


"previous page
9.5. Drive of brakes
following page"
9.5.2. Removal and installation of the vacuum amplifier







7f435ca2