Removal and installation of the rotary switch with a spiral spring (only at a complete set two safety cushions). Nissan Almera (from 1995 to 1999 release)
Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Main data
11.2. Repair of a body
11.3. System of heating and ventilation
11.4. Climatic installation (conditioner)
11.5. System of safety cushions and prednatyazhitel of seat belts
11.5.1. Switching off and turning on of the block of a safety cushion and pyrotechnic device of seat belts
11.5.2. Removal and installation of the block of a safety cushion from the driver
11.5.3. Removal and installation of the rotary switch with a spiral spring (only at a complete set two safety cushions)
11.5.4. Removal and installation of the block of the passenger airbag
11.5.5. Seat belts with a pyrotechnic prednatyazhitel
11.5.6. Removal and installation of the pyrotechnic device of a pretension of seat belts
12. Appendices
13. Schemes of electric equipment
 









11-5-3-snyatie-i-ustanovka-povorotnogo-vyklyuchatelya-so-spiralnojj-pruzhinojj.html

11.5.3. Removal and installation of the rotary switch with a spiral spring (only at a complete set two safety cushions)


Fig. 9.53. Rotary switch: 1 — a tag on a rotor; 2 — a tag on a motionless part;
3 — fastening screws



Remove the safety cushion block from the driver. Disconnect wires of a sound signal and remove a steering wheel, at the same time forward wheels have to be in provision of the rectilinear movement. Remove a steering shaft casing. Turn out four bolts of fastening of the switch (fig. 9.53), disconnect its shtekerny block and take the rotary switch.
Before installation be convinced that forward wheels are in situation for the rectilinear movement. Install the rotary switch, having combined a tag 1 (see fig. 9.53) on a rotor with a tag 2 on a motionless part. Connect a shtekerny block and screw screws of fastening of the switch.
Establish a steering shaft casing. Establish a steering wheel and the block of a safety cushion, having attached wires to a shtekerny block of the block of a pillow and to a sound signal.

"previous page
11.5.2. Removal and installation of the block of a safety cushion from the driver
following page"
11.5.4. Removal and installation of the block of the passenger airbag







7f435ca2