Removal and installation of the block of a safety cushion from the driver. Nissan Almera (from 1995 to 1999 release)
Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Main data
11.2. Repair of a body
11.3. System of heating and ventilation
11.4. Climatic installation (conditioner)
11.5. System of safety cushions and prednatyazhitel of seat belts
11.5.1. Switching off and turning on of the block of a safety cushion and pyrotechnic device of seat belts
11.5.2. Removal and installation of the block of a safety cushion from the driver
11.5.3. Removal and installation of the rotary switch with a spiral spring (only at a complete set two safety cushions)
11.5.4. Removal and installation of the block of the passenger airbag
11.5.5. Seat belts with a pyrotechnic prednatyazhitel
11.5.6. Removal and installation of the pyrotechnic device of a pretension of seat belts
12. Appendices
13. Schemes of electric equipment
 









11-5-2-snyatie-i-ustanovka-bloka-podushki-bezopasnosti-so-storony-voditelya.html

11.5.2. Removal and installation of the block of a safety cushion from the driver


Fig. 9.50. Block of a safety cushion of the driver: 1 — the fastening screw with RESISTORX T50 marking; 2 — the block socket; 3 — the control unit



Switch-off the safety cushion block. Turn out fastening bolts with marking of RESISTORX T50 of the block of a pillow (see fig. 9.50). Slightly raise the block and disconnect its socket. Remove the block of a pillow and put it on storage, following at the same time safety regulations.
You make installation of the block in the sequence, the return to removal. Replace new bolts of fastening of the block. Perform operation of turning on of the block of a pillow.


"previous page
11.5.1. Switching off and turning on of the block of a safety cushion and pyrotechnic device of seat belts
following page"
11.5.3. Removal and installation of the rotary switch with a spiral spring (only at a complete set two safety cushions)







7f435ca2