Dismantling and assembly of a rack of a back suspension bracket. Nissan Almera (from 1995 to 1999 release)
Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.2. Back suspension bracket
7.2.1. Removal and installation of a rack of a back suspension bracket
7.2.2. Dismantling and assembly of a rack of a back suspension bracket
7.2.3. Removal and installation of a beam of a back suspension bracket
7.2.4. Replacement of a nave of a back wheel
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Schemes of electric equipment
 









7-2-2-razborka-i-sborka-stojjki-zadnejj-podveski.html

7.2.2. Dismantling and assembly of a rack of a back suspension bracket


Fig. 5.15. Provision of the lower cup of a spring and top support: And — the arrow indicating to a forward part of the car; B — the left rack;
In — the right rack; 1 — the provision of the lower end of a spring; 2 — an axis, perpendicular axes of an opening of the lower plug of the shock-absorber


Fig. 5.16. Provision of a spring of a suspension bracket:
1 — the lower basic cup of a spring; 2 — the top removable support of a spring; 3 — the top round of a spring


Dismantling of a rack of a back suspension bracket is similar to dismantling of a forward rack. Replacement of shock-absorbers and springs is recommended to be carried out also in pairs, i.e. from the left and right side. At installation of springs and basic cups follow indications of fig. 5.15 and 5.16. Finally tighten threaded connections after lowering of wheels on the earth.


"previous page
7.2.1. Removal and installation of a rack of a back suspension bracket
following page"
7.2.3. Removal and installation of a beam of a back suspension bracket







7f435ca2