Removal and installation of a rack of a back suspension bracket. Nissan Almera (from 1995 to 1999 release)
Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.2. Back suspension bracket
7.2.1. Removal and installation of a rack of a back suspension bracket
7.2.2. Dismantling and assembly of a rack of a back suspension bracket
7.2.3. Removal and installation of a beam of a back suspension bracket
7.2.4. Replacement of a nave of a back wheel
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Schemes of electric equipment
 









7-2-1-snyatie-i-ustanovka-stojjki-zadnejj-podveski.html

7.2.1. Removal and installation of a rack of a back suspension bracket


Fig. 5.13. Fastening of a rack of a back suspension bracket to a body: 1 — bolts of fastening are resistant to a body;
2 — a shock-absorber rod nut


Fig. 5.14. A bolt of fastening of a rack of a back suspension bracket to a beam of a back suspension bracket


Lift a back part of the car, establish on supports and remove a wheel from the necessary party. In the luggage compartment cast away a rug, remove a protective cap and turn off two nuts of 1 (fig. 5.13) of the top fastening of a rack of a suspension bracket. From below the car turn off a bolt of fastening of a rack to a beam of a back suspension bracket (fig. 5.14). Take out a rack through a wheel arch.
You carry out installation as it should be, the return to removal.


"previous page
7.2. Back suspension bracket
following page"
7.2.2. Dismantling and assembly of a rack of a back suspension bracket







7f435ca2 продажа оборудования для майнинга криптовалют