Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
5. Diesel engines
5.1. General information
5.2. Block of cylinders and krivoshipnoshatunny mechanism
5.3. Gas distribution mechanism
5.4. Cooling system
5.5. Lubrication system
5.5.1. General information
5.5.2. Removal, dismantling, assembly and installation of the oil pump
5.5.3. Check of pressure of oil
5.6. Power supply system
5.7. Control system of the CD20 engine
5.8. Control system of the CD20E engine
5.9. System of production of the fulfilled gases
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Schemes of electric equipment
 





7f435ca2


5-5-3-proverka-davleniya-masla.html

5.5.3. Check of pressure of oil


Fig. 3.28. Placement of the sensor of pressure of oil


Remove pressure sensor installed near an oil filter (fig. 3.28).
Connect instead of the sensor the manometer with the scale graduated from 0 to 1000 Pas.
Launch the engine and wait until oil heats up to temperature about 90 °C. Measure oil pressure in the mode of idling and with a frequency of rotation of a bent shaft of 2000 min. — 1.
Pressure of oil has to make in the idling mode 60 Pas, and with a frequency of rotation of a bent shaft of 2000 min. — 1 — 300 Pa.
If the measured pressure does not correspond to the specified values, check operation of the reducing valve and oil pump.

"previous page
5.5.2. Removal, dismantling, assembly and installation of the oil pump
following page"
5.6. Power supply system