Service of Nissan Almera from 1995 to 2000 in N15 body
1. General information
2. General requirements to car repairs
3. Operation and maintenance of the car
4. Petrol engines
5. Diesel engines
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Main data
11.2. Repair of a body
11.3. System of heating and ventilation
11.4. Climatic installation (conditioner)
11.5. System of safety cushions and prednatyazhitel of seat belts
11.5.1. Switching off and turning on of the block of a safety cushion and pyrotechnic device of seat belts
11.5.2. Removal and installation of the block of a safety cushion from the driver
11.5.3. Removal and installation of the rotary switch with a spiral spring (only at a complete set two safety cushions)
11.5.4. Removal and installation of the block of the passenger airbag
11.5.5. Seat belts with a pyrotechnic prednatyazhitel
11.5.6. Removal and installation of the pyrotechnic device of a pretension of seat belts
12. Appendices
13. Schemes of electric equipment
 





7f435ca2


11-5-6-snyatie-i-ustanovka-pirotekhnicheskogo-ustrojjstva-prednatyazheniya-remnejj-bezopasnosti.html

11.5.6. Removal and installation of the pyrotechnic device of a pretension of seat belts


Fig. 9.54. Seat belts with the device of a preliminary tension: 1 — the lower fastening; 2 — the top fastening (a bolt with RESISTORX T50 marking); 3 — the safety lever in position of the switched-on device; 4 — the safety lever in position of the switched-off device



Switch off the block of a safety cushion and the pyrotechnic device of a prednatyazhitel of seat belts. Disconnect the lower fastening of a seat belt (fig. 9.54). Disconnect the regulator of a tension and the top fastening of a seat belt. Switch off the pyrotechnic device, for this purpose lift the safety lever up and its zashplintuyta. Remove the top fastening of the switch of the pyrotechnic device (bolts with the designation RESISTORX T50). Carefully remove the switch (rotor) and disconnect from it brushes.
You make installation as it should be, the return to removal. The safety lever also establish to Rasshplintuyta it in situation "10 hours". Replace RESISTORX bolts. Strictly follow the instruction by preparation of the device for work.

"previous page
11.5.5. Seat belts with a pyrotechnic prednatyazhitel
following page"
12. Appendices