11-4-3-snyatie-i-ustanovka-remnya-privoda-kompressora.html
11.4.3. Removal and installation of a belt of the drive of the compressor
|
Fig. 9.49. Belts of the drive of the service equipment and adjustment of a tension of a belt of the drive of the compressor of the conditioner:
And — the petrol GA14DE engine and the diesel CD20 engine; B — the petrol GA16DE engine; 1 — a pulley of a bent shaft; 2 — a pulley of the pump of the hydraulic booster of steering;
3 — a pulley of the water pump; 4 — a generator pulley; 5 — a compressor pulley; 6 — a tension roller;
7 — a nut of fastening of a tension roller; 8 — the screw for adjustment of a tension of a belt
|
On cars with the GA16DE engine for removal of a belt of the drive of the compressor it is necessary to take off a belt of the drive of the water pump.
On cars with the GA14DE and CD20 engine remove the lower protective guard on the right side of the engine. Weaken a tension of a driving compressor belt, having turned off a nut of a tension roller, then the lower adjusting screw. Take off a driving belt.
You make installation as it should be, the return to removal. At the same time pay attention to the following:
— whether the belt in pulley streams is correctly established;
— whether belts of the service equipment are correctly located;
— whether all belts are correctly tense;
— whether the nut of a tension roller is tightened.
|